Date 1 - 3 of 3
PRI4: AGL network configuration #help
I am working on raspberrypi 4 configuration and have one question.
How AGL configures the eth0 device? What configs/scripts are used to bring up eth0 and request IP address over DHCP?
As I got the systemd-netwotkd.service is used to manage network on AGL (Am I correct?), but I do not see the configuration for eth0 device in /lib/systemd/network.
From system loading I see only that eth0 is up:
[ 13.830234] bcmgenet fd580000.genet eth0: Link is Up - 100Mbps/Full - flow control rx/tx
[ 13.838080] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
Jan Simon Moeller
toggle quoted message Show quoted text
AGL uses connman.
Check the settings ui . There is a section about wired Network.
In the terminal you can use connman_ncurses.
There is an article in AGL wiki about connman that might help:
On 8.04.20 г. 15:29 ч., Jan Simon Moeller wrote:
-- Leon Anavi Software Engineer konsulko.com
|1 - 3 of 3|