Hi,

There is an article in AGL wiki about connman that might help:
https://wiki.automotivelinux.org/connman

Regards,
Leon

Hi!

AGL uses connman.

Check the settings ui . There is a section about wired Network.

In the terminal you can use connman_ncurses.

Best,

Js

<leonid.lazarev@...> schrieb am Mi., 8. Apr. 2020, 14:25:

Hello,

I  am working on raspberrypi 4 configuration and have one question. 

How AGL configures the eth0 device? What configs/scripts are used to bring up eth0 and request IP address over DHCP?
As I got the systemd-netwotkd.service is used to manage network on AGL (Am I correct?), but I do not see the configuration for eth0 device in /lib/systemd/network.

From system loading I see only that eth0 is up:

[   13.830234] bcmgenet fd580000.genet eth0: Link is Up - 100Mbps/Full - flow control rx/tx

[   13.838080] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready

 

Configuration: 

• PPI4,
• icefish (February 2020 build)
• eth cable(with DHCP enabled),

Best Regards
Leonid Lazarev

-- 
Leon Anavi
Software Engineer
konsulko.com

Hello,

I  am working on raspberrypi 4 configuration and have one question. 

How AGL configures the eth0 device? What configs/scripts are used to bring up eth0 and request IP address over DHCP?
As I got the systemd-netwotkd.service is used to manage network on AGL (Am I correct?), but I do not see the configuration for eth0 device in /lib/systemd/network.

From system loading I see only that eth0 is up:

Configuration: 

• PPI4,
• icefish (February 2020 build)
• eth cable(with DHCP enabled),